Engine components, exhaust door, glow time control module, SULEV valve: 10: Fuel injectors, fuel control module: 11: Auxiliary heater heating element 2: 12: Auxiliary heater heating element 3: 13: Automatic transmission control module: 14 – 15: Horn: 16: Ignition coil/power electronics (Plug-in hybrid drive*) 17: ESC control module, engine
Many chain store will prescribe the same glow plug for vehicles from 1996 to 2006 and it ain't so. Your car has glow plugs that work at a different voltage than the pre-2004 cars and are also software update dependent. You will have to know which software is in your engine computer to get it right. The glow-plug light starts flashing and I have to stop and re-start car to reset the limp-mode. The car will be ok as long as I drive it very very gently. My mechanic diagnosed that the turbo variable veins are clogged so I had the turbo taken off and sent to Midland Turbo's to be fully re-conditioned. Glow plug control unit -J179-A2: Up to June 2009, V12: Starter motor relay -J53- From June 2009: Terminal 30 voltage supply relay -J317-A3: CCGA, CCFA, CCFC, V12: Glow time control unit 2 -J703- (CCFA, CCFC from June 2009) A4: Up to June 2009, V12: Starter relay 2 -J695- From June 2009; CCMA, CATA: Relay for additional fuel pump -J832-A5
Control module for glow plug relay location/code no.:. RELAY FOR GLOW PLUG. GLOW PLUG RELAY. ECM. 2010 Audi Q7. Genuine Audi Part - 4E0907282A (4E0-907-282-A). Ships from Jim Ellis Audi Parts, Atlanta GA
001612 - Glow Plug Control Module P064C - 000 - - MIL ON Freeze Frame: Fault Status: 11100000 Fault Priority: 2 Fault Frequency: 1 Reset counter: 255 Mileage: 269095 k Freeze Frame: RPM: 529 /min Speed: 0.0 km/h Voltage: 10.41 V Temperature: 23.4° Bin. Bits: 11000000 Time: 0.00 s Temperature: 21.6°C 001612 - Glow Plug Control Module P064C The code P0671 tells you that something in the glow plug circuit is faulty causing the glow plug on cylinder #1 to fail to heat up. The entire circuit must be checked to locate the fault. Note: If a P0670 trouble code is present along with this DTC, carry out P0670 diagnosis before diagnosing this code. Symptoms. With just one glow plug failure Glow plug control module (651) The part number is: 4L0 907 282 A I looked around and it seems this part is not readily avaliable, so I called Bosch who advised me that they hold the patent on this part and only supply it to Audi, so you'll need to order it through your local main dealership. Im in the UK and was quoted £97.43 for a replacement. I have a Audi A6 3.0 TDI Quattro MY 2007, engine code ASB (171 KW), and the other day the car started to burn glow all glow plugs in a row. First thing I did was to check for any fault codes stored in ECUs with my VAG-COM cable. Found the following: 013112 - Control Circuit for Glow Plug Controller 1 P3338 - 001 - Electrical Malfunction Freeze sLnVyeb.
  • gfe9i6aq96.pages.dev/195
  • gfe9i6aq96.pages.dev/453
  • gfe9i6aq96.pages.dev/779
  • gfe9i6aq96.pages.dev/931
  • gfe9i6aq96.pages.dev/640
  • gfe9i6aq96.pages.dev/942
  • gfe9i6aq96.pages.dev/930
  • gfe9i6aq96.pages.dev/685
  • gfe9i6aq96.pages.dev/904
  • gfe9i6aq96.pages.dev/837
  • gfe9i6aq96.pages.dev/867
  • gfe9i6aq96.pages.dev/632
  • gfe9i6aq96.pages.dev/369
  • gfe9i6aq96.pages.dev/646
  • gfe9i6aq96.pages.dev/293

    • audi q7 glow plug control module location